Iveco — Руководство по ремонту Iveco Trakker Euro 4/5 (EN)

244 F3B ENGINE T RAKKER E URO 4/5  Use 1.75 check. results (3). Use follows. Base q November 2006 Print 603.93.641 ure 259 86939 nnect the pipe from wastegate valve (3) union, then fit e 99367121 (2) pipe to the union. the magnetic-stand comparator (1) tip ontotie rod (4) hen reset the comparator. device 99367121 (2) to let compressed air (pressure: 0.01 bar) into the valve body (3), then make sure that value remains unchanged overthe entire durationofthe . Otherwise, replace the valve, as described in the ant chapter. r the above conditions, the tie rod will have to make a l of 0.43 1.95 mm.

ferent value is found, loosennut (6)and properly rotate d (5) such that tie rod travel at above indicated pressure s to be 0.86 to 1.40. ure 260 86940 wastegate valve (3, Figure 259) turns out to be stuck, nnect tie rod (1) from lever (2), by removing snap ring device 99367121 (2, Figure 259) to convey weak ure into the valve body (3) again, to check whether the is stuck. If so, replace valve (3, Figure 259) as described relevant chapter. rwise, check of the efficiency of the mechanism as s. Figure 261 71770 Take off the cover (1) to be able to inspect the turbine mechanism governed by the actuator.

Figure 262 71771 Check through the inspection hole (2) that the internal linkage control (1) is not stiff or seized; if it is, then lubricate it. And if the defect is not eliminated, replace the turbine. Replacing the wastegate valve (see Figure 260) Take offclip (3) securing tie rod (4) to lever (2), then remove valve (4, Figure 259) from the turboblower by taking off fastening nuts (4, Figure 259). Fit the new valve by reversing the order of disassembling operations, then adjust the tie rod stroke as described in the relevant chapter. NOTE Before fitting the turbocharger to the engine, it is necessary to fill the main body with lubricating oil.