Iveco — Руководство по ремонту Iveco Trakker Euro 4/5 (EN)

DENOX 2 SYSTEM 255 T RAKKER E URO 4/5 Tank  Figure 3 Figure 5 FUNCTIONAL WIRING DIAGRAM 102308 102295 The AdBlue fluid level gauge control consists of a device made up of a set of resistors, a float, a NTC temperature sensor, and a coil used to heat the fluid unde r low temperature conditions. The tank equipped with level gauge control (1) contains the reducing substance required for the SCR process, which consists of a 35%-urea and water solution called AdBlue. It informs the control unit of any current change due to the resistor determined by the float position with respect to the AdBlue fluid level.

AdBlue fluid level gauge control Switch valve Figure 4 Figure 6 108127 FUNCTIONAL WIRING DIAGRAM 1. Coolant inlet - 2. Coolant outlet - 6. Electrical 1. AdBlue liquid discharge line - 2. AdBlue fluid return 116181 connection pipe - 3. Engine cooling hot fluid inlet pipe - 4. AdBlue (NTC) temperature sensor - 5. Engine cooling The valve, which is a Normally Closed type valve, allows AdBlue tank to be heated by engine coolant. The NTC (Figure 5)temperature sensorcontrols the by-pass valve which closes or opens (depending on temperature) the passage of the engine cooling hot fluid into the heating coil. hot fluid outlet pipe - 6. Float (level sensor) - 7. AdBlue fluid heating coil - 8.

AdBlue air vent Print 603.93.641 Base - November 2006