Iveco — Руководство по ремонту Iveco Trakker Euro 4/5 (EN)

22/7 T RAKKER E URO 4/5 GEARBOXESZF 16 S 1620 T.D. - 2220 T.D. - 2520 T.O.  Removing the rear box Figure 6/31 Figure 6/28 37312 71114 Unscrew the screws (1). Screw the eyebolts 99370565 (3) onto the rear box. Using hooks (4) and a movable lift, detach the rear box (2) from the gearbox. Remove the gearbox (1) as described under the relevant heading. Take note of the assembling position of pipes (3) on G.R.E. control cylinder (5), then disconnect thepipes by unscrewing adapters (6) complete with washers.

Removing the epicyclic reduction gear unit (ERG) Figure 6/29 Figure 6/32 102653 Unscrew nut (2), unthread plunger (3) complete with two seal rings and with antivibration ring from rod (5) controlling epicyclic reduction unit. Remove seal ring (6).Takeoff rod (5) seal (4) with a screw driver. Unscrew push rod 145N (1) positioning rod (5). Remove plug (8) and dismount pin (7). 37329 Take off safety plate (if present), unscrew two screws (1), take off push disk (2) and underlying seal ring. Figure 6/30 Figure 6/33 102652 37330 Extract the drive output flange (3) using the extractor composed of: tie rods 99341018 (2), bridge 99341003(1), reaction block 99345058 (4).

Extract 3 epicyclic reduction unit box centering pins (3) by knockout 99340205 (1) and pin 99347092 (2) Print 603.93.641/A Revi - June 2007