English Follow the steps below: 1. Load a paper roll in the printer; turn off the power; then open the paper roll cover and turn the power back on while holding down the RELEASE button. 2. Press the RELEASE button seven times; then close the paper roll cover. The printer prints the following message on receipt paper and the SLIP light flashes. 3. Insert the cleaning sheet like a standard check. CAUTION: Be sure that the sheet is inserted with the correct side up and that it is inserted in the correct direction. Use a cleaning sheet only one time; then discard it. 4. When the sheet is ejected, press the RELEASE button, and remove the sheet from the printer.
Notes on Using the MICR Reader Do not install the printer near any magnetic fields. Be especially careful where you install your display device and be sure to check the recognition rate of the MICR reader with the display device in place. Make sure that the printer is not subjected to any impact or vibration when it is performing a MICR reading. TM-U675/U675P Specifications TM-U675/TM-U675P User’s Manual 11 Print method: 9-pin serial impact dot matrix Print font: 5 × 9 / 7 × 9 Columns: 37 / 50 columns (receipt) 45 / 60 columns (slip/validation) Character size: 1.56 mm × 3.1 mm / 1.24 mm × 3.1 mm {0.006” × 0.12” / 0.49” × 0.12”} Character sets:
95 alphanumeric, 37 international characters 128 × 12 pages extended graphic characters Print speed: Approximately 5.14 LPS (40 columns at 17.8 CPI) Paper dimensions: