Ethernet Communication Module IFD9506 gateway, and the gateway will send the packet to another subnet. Incorrect setting may cause the destination equipment unable to communicate to IFD9506. To see if your setting is correct, conduct bitwise AND operations between your IP and subnet mask and destination IP and subnet mask. If the two values obtained are the same, the two IPs are in the same subnet. The default subnet mask of IFD9506 is 255.255.255.0. D. Gateway: Gateway is the window for two different subnets, allowing the two ends in different subnets to communicate. For example, if the LAN has to be connected to WAN, it will need a gateway to bridge the communication.
The IP of the gateway has to be in the same subnet as IFD9506. The default gateway of IFD9506 is 192.168.1.254. 4. Communication parameter setting: Please refer to explanations on BR#4, BR#5, and BR#6. 5. Timer setting: For setting up TCP connection idle time, Modbus time-out and minimum communication delay time for every communication data. Please refer to explanations on BR#11, BR#12, and BR#13. 8.3 Network Settings The IP address is like a number for every equipment to be identified on the network. The first step for all the equipment to connect to the network is to have its own IP (Internet Protocol) address. ѓ Setting up static IP of the PC 1.
Enter Control Panel → Network Connection → click on “Local Area Connection”. 2. You will see the “Local Area Connection Status” window. Click on “Properties”. DVP-PLC Application Manual 20