Ethernet Communication Module IFD9506 1 Introduction To ensure correct installation and operation of IFD9506, please read this chapter carefully before using your IFD9506. IFD9506 is an Ethernet communication module for remote setting through Delta’s DCISoft or remote setting and communication through WPLSoft. IFD9506 has 3 digital input contacts on it. They will send out messages to designated E-Mail addresses once being triggered. IFD9506 supports Modbus TCP protocol and can be used for remote monitoring with graphic control software or human machine interface. IFD9506 can be Modbus TCP master, sending out Modbus TCP commands and controlling the peripheral equipment.
IFD9506 can be a slave as well, receiving Modbus commands sent out from another master and sending the command to another Modbus communication network through Ethernet. In addition, in MDI/MDI-X auto-detect, jump wire is not needed when you choose the network cable. 1.1 Features z Auto-detects 10/100 Mbps transmission speed; MDI/MDI-X auto-detect. z The monitor table temporarily stores the monitored data for you to fast save or acquire the data. z Supports Modbus TCP protocol (both master and slave modes) z Able to send out E-Mails when triggered. z The station address, RS-485 communication format and baud rate can be set up externally.
1.2 Specifications ѓ Ethernet interface ѓ COM1 ѓ COM2 DVP-PLC Application Manual 3 Interface RJ-45 with Auto MDI/MDIX Number of ports 1 port Transmission method IEEE802.3, IEEE802.3u Transmission cable Category 5e Transmission speed 10/100 Mbps Auto-Defect Communication protocol ICMP, IP, TCP, UDP, DHCP, SMTP, Modbus TCP Interface Mini Dim Number of ports 1 port Transmission method RS-232 Transmission cable DVPACAB215 / DVPACAB230 / DVPACAB2A30 Transmission speed 110/150/300/600/1200/2,400/4,800/9,600/19,200/38,400/57,600/115,200 Communication protocol Modbus, Delta Configuration, User Define Interface RJ-11 Number of ports 1 port Transmission method RS-485