Fig. 17 To pack the appliance away, pull the handle out of the telescopic tube ( Fig. 3 ). Slot the adapter into the stand on the rear of the appliance. Coil the suction hose around the appliance and secure it in the bottom clamp in the hose clip. Coil the suction hose around the appliance a second time and secure the handle in the top clamp in the hose clip. Finally, release the suction adapter, pull it out of the appliance and clip it onto the handle ( Fig. 2 ). Exhaust filter care Press the catch on the left-hand side to open the exhaust grille. Press the catch at the top of the exhaust filter to release the filter, and take it out of the appliance.
Tap the exhaust filter and wash it under running water. Once it is completely dry, place the exhaust filter back in the appliance and close the exhaust grille. Fig. 21 Always switch off the vacuum cleaner and unplug the mains plug before cleaning the vacuum cleaner. The va- cuum cleaner and plastic accessories can be cleaned with standard plastic cleaner. ! Caution: Do not use abrasive cleaning products, glass clea- ner or multi-purpose cleaning products. Never im- merse the vacuum cleaner in water. Cleaning instructions Cleaning and care Fig.
18 In order to achieve the best possible vacuuming re- sults, the dust container should be emptied after every use or, at the latest, when dust at one point in the con- tainer has reached the mark. Emptying the dust container Subject to technical modifications. Press the release button to release the dust contai- ner, and take hold of the handle to remove it from the appliance. Hold the dust container over the dustbin and press the release button to release the bottom cover. The dirt and dust will then fall straight into the bin. Close and lock the bottom cover. Insert the dust container into the appliance and lock it in place. Fig.
19 Maintaining the dust-separation system To keep them in good working order, the filters should be cleaned at least every 3 months. Cleaning the filter in the dust container Fig. 20 Switch off the appliance. Open the lid on the dust container by pulling on the lower catch. Remove the frame with the filter from the lid. Remove the filter foam from the filter frame. If necessary, remove any hair and dust, and tap the motor protection filter and filter foam. Both filters and the dust container can be washed under running water. After cleaning and thoroughly drying them, reas- semble all the parts and place them back in the appliance. !
Caution Do not place the parts back in the appliance before they are completely dry. ! Never use the vacuum cleaner without the filter. => This may damage the appliance. 31 * Depending on model