hp Color 9850mfp PROCESS UNIT 4.11 roller Replacing the 1st transfer A. Periodically replaced parts/cycle • 1st transfer roller Y, M, C, K: Every 200,000 copies B. Procedure 1. Remove the transfer belt. (See " 4.10 Replacing the transfer belt. ") [7] [5] 2. Place the transfer belt unit as shown in the illus- tration. 3. Remove the stop ring [1]. 4. After removing 1 bearing [2], slide the stopper /4 [3] to open the tip end of the transfer release arm [4]. 5. Remove the 1st transfer roller K [6] while sliding [7] it. [7] 6. Remove three 1st transfer rollers Y, M, C [5]. III DIS./ASSEMBLY Note:
[7] [6] [4] [3] [3] [4] • Be sure to reinstall the 1st transfer roller so that a shallow groove near the groove of the E-ring comes this side. 7. Remove the E-rings [7], 2 each, from each of 8. Reinstall the above parts following the removal the 1st transfer rollers. steps in reverse. [2] [1] 3-43