hp Color 9850mfp PAPER FEED TRAYS 1 to 3 B. Attaching the wire 4. After winding the wire C [3] and the wire D [10] around the pulley [11], insert it into the shaft [13] Note: • Since the composition of the paper feed trays together with the wire restraining cover [12] and fasten it with an E-ring [14]. 1 to 3 is the same, the explanation here is made of the steps for the paper feed tray 1. Note: 1. Install the wire C [3] to the wire holding shaft [2] • Be sure to wind the wires around the pulley [11] so that the wire C [3] comes to the out- with a screw [1] from the bottom side of the side and the wire D [10] to the inside. paper feed tray. 2.
[4], insert it into the shaft [6] together with the After winding the wire C [3] around the pulley 5. After sliding the drive pulley [15] to the outside with the wire C [3] and the wire D [10] inserted wire restraining cover [5] and fasten it with an E- into the up/down drive shaft [14], fasten it with ring [7]. an E-ring [16]. 3. [9] with a screw [8] from the bottom side of the Install the wire D [10] to the wire holding shaft paper feed tray. III DIS./ASSEMBLY [5] [12] [11] [7] [4] [13] [4] [3] [6] [3] [8] [10] [9] [16] [15] [14] [1] [2] [17] [18] [17] 3-66