STACKER Q5686A/Q5687A 3.2.2 Alignment L control ( Q5687A only) In the stitch-and-fold mode, folding mode and three-folding mode, the alignment of paper along the width is made by oscillating the alignment plate U and the alignment plate L. The alignment plate L is oscillated by rotating the alignment motor L (M716) in the normal or reverse direction. The home position of the alignment plate /L is detected by the alignment HP PS/L (PS724). A. Alignment L control In the folding, stitch-and-fold and three-folding modes, an finisher operation signal from the finisher starts II UNIT EXPLANATION to rotate the alignment motor L (M716) in the direction in which the alignment plate L closes.
And the width. motor stops at the stand-by position in which the alignment plate L opens a little wider than the paper A specified period of time after the stacker entrance sensor (PS705) detects the trailing edge of paper, M716 rotates in the normal or reverse direction to oscillate the alignment plate L for proper alignment of paper. Alignment is made each time a sheet of paper is sent in. [1] [3] Alignment operation Finisher operation start signal ON [2] Standing by for paper size 3.2.3 Stopper control ( Q5687A only) fold and the three-folding modes.
The longitudinal position of paper conveyed to the stacker varies for each of the staple, folding, stitch-and- The longitudinal position of paper is controlled by the two stoppers (booklet stopper and flat-stapling stop- per). 2-16 Stacker entrance sensor (PS705) Alignment HP sensor L (PS724) Alignment motor L (M716) OPEN CLOSE [1][2] [3]