Q5690A TRAY UP/DOWN C. Reinstalling the wire 1. Insert the up/down wire A [2] into the hole [1] provided on the upper surface of the HCI main body. [7] [6] [2] 2. Reinstall the up/down wire A [2] onto the guide [2] [1] pulleys [3], [4] and [5] in this order. [4] Note: • When reinstalling the up/down wire A [2] onto the guide pulleys [3], [4] and [5], be sure to insert the wire into the pulley through the notch [6] provided on the side of each pulley [2] and then move the wire cover [7] of each pul- [5] ley to the wire that has been already inserted.
When moving the wire cover [7], move it first to the position where the notch [6] can be [3] avoided and then move the wire in the notch [8] [6] into each pulley. [10] 3. Insert the up/down wire A [2] into the wire [2] [11] [10] [12] III DIS./ASSEMBLY installation hole [9] provided inside the up/down [6] [2] [7] [9] drive shaft [8]. [8] Note: • The up/down drive shaft [8] is provided with 3 wire installation holes each on the front side and the rear side. In this step, the inner-most wire installation hole is used. 4. Insert the drive pulley [10] into the up/down drive shaft [8] so that the notch [11] of the drive pulley [10] comes to the position in which the up/down wire A [2] is put. 5.
Fit the E-ring [12] and fasten the drive pulley [10]. 3-19