Stapler door assembly with label/stacker door assembly 1 Open the door assembly and, on a stapler/stacker, center the stapler unit. 2 Use the TX-20 screwdriver to remove two screws (callout 1) from inside the door, one at the front and one at the back of the device. Note The screws remain attached to the plastic screw holders. 3 Rotate the door down until the flat sides of the hinges are parallel to the floor and pull the door straight away from the product. Controller PCA cover (with label) 1 Use the TX-20 screwdriver to remove the upper and lower screws (callout 2) from the cover. 2 Rotate the cover to clear the tabs at the back of the product and lift the cover away from the product.
21 2 Figure 192. Stapler door assembly and controller PCA cover removal 342 Chapter 6 - Removal and replacement EN