15 Press – V ALUE + to set the correct compensation (in millimeters). 16 Press S ELECT . 17 Repeat steps 9 through 16 until you are comfortable with the staple position. 18 Press M ENU until Configuration of Stkr appears. 19 Press I TEM until Calibra Values appears. 20 Press – V ALUE + until Set appears. 21 Press S ELECT . 22 Press G O . If you set compensation values, the printer should return to Ready automatically and the user LED should return to the solid green status. Because you set calibration values, the printer should not allow access to the compensation values in service mode. If you did not set compensation values, repeat steps 1 through 4 and steps 18 through 22.
Y-axis X-axis Figure 239. Staple position EN 3,000-sheet stapler/stacker troubleshooting 483 Staple position Staple + – – + Staple