Table 26. Service Mode Menu (continued) Service Mode Menu Item Value Description/action REPEAT= NO* YES ON FAULT= BREAK* CONT PAUSE BREAK stops at error and only the printer control panel displays a message. CONTINUE does not stop at error, and error is posted only to the fault log. PAUSE stops at error and the printer control panel displays a message. Press S ELECT to continue. Then, error is also posted to the fault log. ROM CRC= YES* NO Firmware read-only memory (ROM) is tested. DRAM DIMM= YES* NO Installed DIMMs are tested to verify that they are supported by the formatter board and functioning properly.
IDE ASIC= YES* NO This test verifies the read and write integrity of the formatter IDE ASIC. DISK= YES* NO Used to verify the integrity of the printer hard disk and the interface between the printer hard disk and the printer. This test also ensures that the printer hard disk buffering and caching are working properly. VX ASIC= YES* NO This test verifies the read and write integrity of the formatter VX ASIC. FAULT LOG first fault message . . . last fault msg Records all errors that occurred while formatter diagnostics tests were executing. FAULT LOG does not appear until the formatter diagnostics have been run and a failure exists. The fault log is cleared when the printer is turned off.
POWER OFF TO EXIT Turn the printer off and on to exit the formatter diagnostics and reset the printer. PAPER PATH EXECUTE TEST Press S ELECT to execute tests. * Default setting. EN Menu maps 95