Selecting the display language The printer supports printer messages and prints configuration pages in a variety of languages. Use the printer control panel to set the display language. 1 To enter configure language mode, hold down S ELECT while turning the printer on. When CONFIG LANGUAGE (in English) appears on the printer control panel display for approximately one second, release S ELECT . Once the printer has restarted, LANGUAGE = ENGLISH appears on the display. Note Only – V ALUE + , S ELECT , and G O are active while the display language is being configured. All other keys are ignored.
If you press G O without selecting a language, the printer brings itself online and all subsequent messages are in English. However, because no display language was selected, the LANGUAGE = ENGLISH message reappears (after the power-on self test) when the printer is turned on again. This message appears every time the printer is turned on until you select a language through the configure language mode. 2 Press – V ALUE + until the language you want appears on the display. 3 Press S ELECT to save the selection. An asterisk (*) appears to the right of the selection.
The language selected is the default language until another selection is made by restarting the printer in the configure language mode. 4 Press G O . 5 Turn the printer off and back on. Note See the HP Color LaserJet 8550 MFP printer Service Manual for information about how to change the display language on the copy module. EN Selecting the display language 97