Multi-axis controllers Installation of the standard device 5 5.6 5.6 Installation of the standard device How to proceed: 1. Insert the device into the installation backplane without twisting it until resistance is felt. 2. Press the device into the installation backplane until it audibly snaps into place. The locking clip moves downwards and back into the locking position. 3. The end position is reached when the locking clip can be pressed against the device. Now the device is locked. SSP94GG102 Fig. 5.6-1 Installation of the device Proceed as follows to remove the device: 1. Disconnect already wired connectors at the device. 2.
Push the locking clip downwards to release the device and disengage it from the contacts. 3. Pull the device completely out of the installation backplane and remove it. The locking clip moves back into the locking position. 5.6-1 EDS94SPP101 EN 3.1-04/2007