Single-axis controllers Wiring Devices in the range 2 ... 24 A (0.37 ... 11 kW) 4 4.6 4.6.3 Motor temperature monitoring Motor brake control (optional) Stop! The motor brake control includes an electronic switch which can control a 24 V motor holding brake. The motor brake control may only be connected with motor holding brakes which correspond to the permissible data mentioned in the technical data. (If required, the holding brake without motor brake control must be controlled via a digital output and a coupling relay). If the permissible data mentioned in the technical data are not complied with: ƒ the motor brake control can be destroyed.
ƒ a safe operation of the motor holding brake cannot be guaranteed. Further notes in the documentation of the basic device must be observed! 4.6-13 EDS94SPP101 EN 3.1-04/2007 Terminal X106 Labelling Description T1 T2 Terminal d ata Max. conductor cross-section [mm2] [AWG] Tightening torque Screw drive [AWG] [Nm] [lb-in] Flexible end 2.5 12 0.5 ... 0.6 4.5 ... 6.2 PZ0 With wire ferrule Terminal X107 Labelling Description SSP940X107 BD1 BD2 Connection of the motor holding brake + (Lenze: WH) - (Lenze: BN) E94AZHX0051: 24 V DC, max. 2.5 A Observe correct polarity! + / - Supply voltage for the motor holding brake (18 ... 30 V DC) Observe correct polarity! Terminal d ata Max.
conductor cross-section [mm2] [AWG] Tightening torque Screw drive [AWG] [Nm] [lb-in] Flexible end 2.5 12 0.5 ... 0.6 4.5 ... 6.2 PZ0 With wire ferrule