User Manual of A90 Series Inverter (c) Wiring diagram of two-line control (F00.03=1) (d) Forward/reverse running logic (F04.19=0, F00.03=1) Fig. 7-1 Two-line Control When the start/stop value of F00.03 is set to 0 or 1, even if the terminal RUN is available, the inverter can be stopped by pressing the STOP key or sending an external stop command to the terminal. In this case, the inverter will not be in the running status until the terminal RUN is disabled and then enabled. Three-line control: F00.03=2: the terminal RUN controls forward running, the terminal Xi is for stop, and the terminal F/R is in the reverse status. normally ON for reverse running, with valid pulse edges.
The terminal Xi is normally The terminal RUN is normally ON for forward running, and the terminal F/R is closed for stop, with the valid level. When the inverter is in the running status, press Xi to stop it. When the mode of deceleration to stop (F04.19=0) is selected, the logic diagram is as shown in Fig. 7-2(b). The terminal Xi is for “three-line running and stop control” as defined by F02.00 to F02.04. F00.03=3: the terminal RUN is for running, Xi for stop and F/R for forward/reverse control.
The terminal RUN is normally ON for running, with the valid pulse edge, F/R for forward/reverse switching (forward in the OFF status and reverse in the ON status), and Xi is normally OFF for stop, with the valid level. When the mode of deceleration to stop (F04.19=0) is selected, the logic diagram is as shown in Fig. 7-2(d). 24V RUN Forward RUN F/R Inverter F/R Xi Xi Parking f COM Output frequency Time -f (a) Wiring diagram of three-line control (b) Forward/reverse running logic 117