User Manual of A90 Series Inverter user should select specific function codes by setting the parameters of the F11 group. Then the user-selected mode (--U--, as detailed in 4.2.2) can be enabled. The selected function codes can be switched cyclically via the Up or Down key. This function is mainly used where less than 32 specific function codes are involved, which can avoid the trouble caused by too many function codes.
214 Function Function Parameter description Unit Default setting Attribute code code name F11.00 User-selected parameter 1 U00.00 ● F11.01 User-selected parameter 2 U00.01 ● F11.02 User-selected parameter 3 U00.02 ● F11.03 User-selected parameter 4 U00.03 ● F11.04 User-selected parameter 5 U00.04 ● F11.05 User-selected parameter 6 U00.07 ● F11.06 User-selected parameter 7 U00.14 ● F11.07 User-selected parameter 8 U00.15 ● F11.08 User-selected parameter 9 U00.16 ● F11.09 User-selected parameter 10 U00.18 ● F11.10 User-selected parameter 11 U00.19 ● F11.11 User-selected parameter 12 U00.29 ● F11.12 User-selected parameter 13 U02.00 ● F11.13 User-selected parameter 14 U02.01 ● F11.14 User-selected parameter 15 U02.02 ● F11.15 User-selected parameter 16 U03.00 ●