User Manual of A90 Series Inverter Fig. 4-4 Example of User-defined Mode Setting In the user-defined mode, press the ENTER key to enter the Level 2 menu. The Level 2 menu only displays 32 user-defined parameters in the F11 group. The user can enter the F11 group from the full menu mode to set these function codes. After the function codes are defined in the F11 group, enter the user-defined mode. Then we can see F00.07 defined by the first function code F11.00, F00.09 defined by the first function code F11.01, and so on to F11.31, 32 in total. Function code modification in the Level 3 menu is equivalent to that in the full menu mode, and the modification method is also the same.
In the Level 2 menu of the user-defined mode, press the increment or decrement key on the keyboard to change the function code defined by F11.00 to that defined by F11.31. When the right shift key is pressed in the Level 2 menu, the cursor will not shift. Press the ENTER key to enter the Level 3 menu. If the displayed function code is modifiable currently, the lowest bit indicated by the cursor will flicker. Parameter modification is the same as that in the Level 3 menu under the full menu mode. After 52