User Manual of A90 Series Inverter Chapter 6 Function Code Table 6.1 Description of Function Code Table The function codes of the A90 series inverter (hereinafter referred to as the “function codes”) are divided into 24 groups in Table 6-1, and each group contains several function codes. Among them, the F18 group is a monitoring parameter group used to view the inverter status; the F19 group is a fault record group used to view the details of the last three faults; and other groups are parameter setting groups to meet different functional requirements. Table 6-1 Introduction to Function Code Groups ★ Some parameters of the current series are reserved, and their readings are 0.
Some options of parameters are reserved and settable, but this may result in abnormal operation of the inverter. Please avoid misuse of such parameters.
63 F00 Basic function parameter group P65; P114 F01 Parameter group of motor 1 P68; P132 F02 Input terminal function group P70; P137 F03 Output terminal function group P74; P149 F04 Start/stop control parameter group P77; P161 F05 V/F control parameter group P79; P168 F06 Vector control parameter group P81; P174 F07 Protection function setting group P84; P181 F08 Multi-segment speed and simple PLC P86; P188 F09 PID function group P93; P198 F10 Communication function group P95; P209 F11 User-selected parameter group P96; P213 F12 Keyboard and display function group P97; P216 F13 Torque control parameter group P100; P221 F14 Parameter group of motor 2 P101; P228 F15 Auxiliary function group P105; P229 F16 Customization function group P107; P222 F17 Virtual I/O function group P108; P241 F18 Monitoring parameter group P110; P245 F19 Fault record group P111; P248