Edge1PolarityMode Edge1PolarityMode VPARAMETER 5211 Selection criterion for the first edge of the selected pair. The greyscale transition of the edge must respect the polarity set by this property. Syntax Micro V+ VPARAMETER (sequence_id, tool_id, 5211, index_id, object_id) = value value = VPARAMETER (sequence_id, tool_id, 5211, index_id, object_id) V+ VPARAMETER (sequence_id, tool_id, 5211, index_id, object_id) $ip = value value = VPARAMETER ($ip, sequence_id, tool_id, 5211, index_id, object_id) Type Long Range Parameters ACE Reference Guide, 18317-000 Rev A Page 179 Value Polarity Mode Name Description 0 hsDarkToLight The greylevel value must go from dark to light when crossing an edge.
1 hsLightToDark The greylevel value must go from light to dark when crossing an edge. 2 hsEitherPolarity The change in greylevel value is not a criterion for locating an edge. $ip IP address of the vision server. Applies to V+ syntax only. Uses standard IP address format, for example: 192.168.1.120. sequence id _ Index of the vision sequence. The first sequence is 1. tool id _ Index of the tool in the vision sequence. The first tool is 1.