OutlineLevel OutlineLevel VPARAMETER 300 The coarseness of the contours at the Outline level. This property can only be set when ParametersBasedOn is set to hsParametersCustom. Otherwise, it is read-only. Syntax MicroV+ value = VPARAMETER (sequence_id, tool_id, 300, index_id, object_id) V+ value = VPARAMETER ($ip, sequence_id, tool_id, 300, index_id, object_id) Remarks For most applications, the ParametersBasedOn property should be set to hsParametersAllModels. Custom contour detection should only be used when the default values do not work correctly. Type Long Range Minimum: 1 Maximum: 16 Parameters ACE Reference Guide, 18317-000 Rev A Page 404 sequence id _ Index of the vision sequence.
The first sequence is 1. tool id _ Index of the tool in the vision sequence. The first tool is 1. ID 300: the value used to reference this property. index id _ N/A object id _ N/A $ip IP address of the vision server. Applies to V+ syntax only. Uses standard IP address format, for example: 192.168.1.120.