SequenceExecutionMode SequenceExecutionMode VPARAMETER 10200 Sets the mode for execution of the sequence. When VRUN is called the sequence is run if single execution mode is selected (0) or in continuously if continuous mode is selected.
Syntax MicroV+ VPARAMETER (sequence_id, tool_id, 10200, index_id, object_id) = value value = VPARAMETER (sequence_id, tool_id, 10200, index_id, object_id) V+ VPARAMETER (sequence_id, tool_id, 10200, index_id, object_id) $ip = value value = VPARAMETER ($ip, sequence_id, tool_id, 10200, index_id, object_id) Type Long Range Parameters ACE Reference Guide, 18317-000 Rev A Page 492 Value Execution Mode Description 0 Single execution Executes the vision sequence once. 1 Continuous mode Executes the vision sequence continuously, until the execution is stopped by a program instruction. sequence id _ Index of the vision sequence. The first sequence is 1. tool id _ Should always be set to -1.
ID 10200: the value used to reference this property. index id _ N/A