ToolPositionY ToolPositionY VPARAMETER 101 Y-coordinate of the center of the tool region of interest. Syntax MicroV+ VPARAMETER (sequence_id, tool_id, 101, index_id, object_id) = value value = VPARAMETER (sequence_id, tool_id, 101, index_id, object_id) V+ VPARAMETER (sequence_id, tool_id, 101, index_id, object_id) $ip = value value = VPARAMETER ($ip, sequence_id, tool_id, 101, index_id, object_id) Type Double Range Unbounded Parameters ACE Reference Guide, 18317-000 Rev A Page 521 $ip IP address of the vision server. Applies to V+ syntax only. Uses standard IP address format, for example: 192.168.1.120. sequence id _ Index of the vision sequence. The first sequence is 1.
tool id _ Index of the tool in the vision sequence. The first tool is 1. ID 101: the value used to reference this property. index id _ N/A object id _ N/A