Introduction 1.2 Module Orientated Programming Programming under KUBES is module orientated, i.e. you divide your overall problem up into a number of coherent subtasks. You then work through each of these individual sections (modules). The individual modules form a hierar- chical system in which higher-level modules call up lower- level ones. The transparency of complex programs is thus enhanced considerably. There are also pre-programmed modules available for special tasks (KUBES modules). 1.3 Target Systems Use KUBES to program any of the following Kuhnke PLC systems.
Overview ѕ Modu Control 657, 657P ѕ Compact Control 667, Pico Control 667 ѕ Eco Control 667 ѕ Compact Control 680C ѕ KDT 680CT ѕ Profi Control 680I, 680V, 645-500, 645-12M ѕ ProfiControl 690PLC+ ѕ PC Control 644, 645-500, 645-12M ѕ CanControl 691, CanControl 690PLC+ ѕ DriveControl 682 DP You can also use KUBES for a variety of customised con- trollers. E 327 GB 9 10.06.2003