NC Error Codes 4 NC Error Codes 4.1 General NC Errors Diagnostics 61 Version: 1.0 Error(Hex) Error(Dec) Error Type Description 4000 16384 Internal "Internal error" Internal system error in the NC on ring 0, no further details. 4001 16385 Memory "Memory error" The ring-0 memory management is not providing the required memory. This is usually a result of another error, as a result of which the controller will halt normal operation (now if not before). 4002 16386 Internal "Nc retain data error (persistent data)" Error while loading the Nc retain data. The axes concerned are no longer referenced (status flag "Homed" is set to FALSE). Possible reasons are:
- Nc retain data not found - Nc retain data expired (old backup data) - Nc retain data corrupt or inconsistent 4003 16387 Parameter Parameter for Monitoring the NC Setpoint Issuing is Invalid The parameter for activating or deactivating the function “cyclic monitoring of NC setpoint issuing on continuity and consistency” is invalid. (Special function.) 4004 16388 Internal External Error This error code can be set by an external module (e.g. third-party module) or can be set when an external module exhibits an error. 4010 16400 Parameter "Channel identifier not allowed" Either an unacceptable value (not 1...255) has been used, or a channel that does not exist in the system has been named.
4011 16401 Parameter "Group identifier not allowed" Either an unacceptable value (not 1...255) has been used, or a group that does not exist in the system has been named. 4012 16402 Parameter "Axis identifier not allowed" Either an unacceptable value (not 1...255) has been used, or an axis that does not exist in the system has been named. 4013 16403 Parameter "Encoder identifier not allowed" Either an unacceptable value (not 1...255) has been used, or a encoder that does not exist in the system has been named. 4014 16404 Parameter "Controller identifier not allowed" Either an unacceptable value (not 1...255) has been used, or a controller that does not exist in the system has been named.
4015 16405 Parameter "Drive identifier not allowed" Either an unacceptable value (not 1...255) has been used, or a drive that does not exist in the system has been named. 4016 16406 Parameter "Table identifier not allowed" Either an unacceptable value (not 1...255) has been used, or a table that does not exist in the system has been named. 4020 16416 Internal "No process image" No PLC-axis interface during creation of an axis.