D ISARMING A SPLIT SYSTEM AFTER AN ALARM The bells and the flashing light are activated when an alarm is triggered in the system. If your system has the option, a report of the event is automatically sent over the phone lines to a central station. If you inadvertently activate an alarm, immediately telephone the central station to prevent an unnecessary response. When you enter the premises after an alarm, the bell may already be silent if it has been so programmed, but the red LED will still be activated. This allows there to be several alarms. Remember to record the fault or alarm in your logbook for future reference.
If your code allows you to access more than one security area, you can select one of them to disarm. 1. Go to the keypad. The entry period starts as soon as you open the entrance door, or when you enter the entry zone. You can switch off the system without activating the alarm as long as the beeping continues. The red LED ALARM is lit on the keypad. Beep Beep The standby display is displayed. An example is shown. TUE 23 APR 07.39 2. Press the key 0 and then enter your code. A ‘*’ appears in the display for every key you press. Use the 0 key to cancel an incorrect entry and to restart a new entry of the code.
Enter Code 0 + code Enter Code **** In this example, the area 1 alarm has been triggered and area 2 is armed. Area 1 Alarm Area 2 Armed Enter Area No. 3. Enter the area number where the alarm occurred (in this example it is 1). You have a few seconds to enter the number. 1 Disarm? 4. Press the Accept key to disarm the selected area (area 1 in this example). ! A list of where the alarm was triggered is presented. Events in Log... In this example, the alarm was triggered in zone 4 ‘Back Door’ on 23 April at 7.40am in area 1. 004 Alarm 004 Back Door 23 APR 05.20 A1 5. Press the Accept key to confirm the alarm. ! Area 1 Disarmed Page 16 User Manual for CD72/95/15003