AH Motion Controller – Operation Manual Length of a cutting=Circumference of the blade used: The cutting roller used rotates at a uniform speed. Ratio of the speed of the slave axis to the speed of the master axis 1 Position of the master axis One time the circumference of the blade used used: After the cutting roller used completes cutting in the synchronization zone designed, it will decelerate, and then accelerate until its speed is the same the speed of the feeding roller used. Ratio of the speed of the slave axis to the speed of the master axis Synchronization zone Position of the master axis Length of a cutting>Two times the circumference of the blade used:
The length of a cutting is greater than two times the circumference of the blade. (It is a common situation.) After the blade used completes cutting in a cycle, it will decelerate until it stops. After a material of a certain length is fed, the blade used will start cutting again. Ratio of the speed of the slave axis to the speed of the master axis Synchronization zone Position of the master axis _7 7-42