AH Motion Controller – Operation Manual _9 9-10 Error code Description CPU Status LED indicator status ERROR BUS FAULT 16#1402 The actual arrangement of the I/O modules is not consistent with the module table. (SM9) Stop Keep ON 16#1403 An error occurs when the data is read from the module. (SM9) Stop Keep ON 16#1405 The setting parameter of the module is not found. (SM9) Stop Keep ON 16#140B The number of network modules exceeds the limit. (SM9) Stop Keep ON 16#140C The checksum of the high-speed data exchange is incorrect. Stop Keep ON 16#140D The ID of the actual power supply module is not the same as the ID of the power supply module set in HWCONFIG.
(SM9) Stop Keep ON 16#140E The amount of data exchanged at a high speed exceeds the maximum amount supported. Stop Keep ON 16#140F High-speed data exchange error Stop Keep ON 16#1801 There is no interrupt service routine in the CPU module. Continue Keep Keep 16#2000 There is no END in the program in the PLC. (SM5) Stop Blinking Keep 16#2001 The program is incorrect. There is a syntax error. Stop Blinking Keep 16#2002 GOEND is used incorrectly. (SM5) Stop Blinking Keep 16#2003 The devices used in the program exceed the range. (SM0/SM5) Self-defined Blinking Keep 16#2004 The part of the program specified by the label used in CJ/JMP is incorrect, or the label is used repeatedly.
(SM0/SM5) Stop Blinking Keep 16#2005 The N value used in MC is not the same as the corresponding N value used in MCR, or the number of N values used in MC is not the same as the number of N values used in MCR. (SM5) Stop Blinking Keep 16#2006 The N values used in MC do not start from 0, or the N values used in MC are not continuous. (SM5) Stop Blinking Keep 16#2007 The operands used in ZRST are not used properly. (SM5) Stop Blinking Keep 16#200A Invalid instruction (SM5) Stop Blinking Keep 16#200B The operand n or the other constant operands exceed the range. (SM0/SM5) Self-defined Blinking Keep 16#200C The operands overlap.
(SM0/SM5) Self-defined Blinking Keep 16#200D An error occurs when the binary number is converted into the binary-coded decimal number. (SM0/SM5) Self-defined Blinking Keep 16#200E The string does not end with 0x00. (SM0/SM5) Self-defined Blinking Keep 16#200F The instruction does not support the modification by an index register. (SM5) Stop Blinking Keep 16#2010 1. The instruction does not support the device. 2. Encoding error 3. The instruction is a 16-bit instruction, but the constant operand is a 32-bit code. (SM5) Stop Blinking Keep 16#2011 The number of operands is incorrect. (SM5) Stop Blinking Keep