Chapter 2 Installing Hardware 2.3.3 Installing a Dust Cover Installing a dust cover : Hook the dust cover onto the lower slot indicated by ”1“. Press the cover down in the direction as “2” indicated and then press the cover click indicated by ”3“ to have it clicked into the upper slot. Remove the dust cover: Press to release the cover click indicated by ”3“ from the upper slot and pull it up in the direction as “4” indicated. 2.3.4 Installing a Module Insert a module into a slot, make sure that the module is installed on the backplane properly, and tighen the the screw, as illustrated below. 1. Insert the projection under the module into the hole in the backplane. 2.
Push the module in the direction indicated by the arrow until it clicks. 2-13