AH500 Module Manual Example: when AH15EN-5A is as a master, it will scan and obtain the IOA of the remote device. Create type ids to correspond to the CPU registers as the starting position for data mapping and the obtained value will be stored to the specific register. Users can input the values according to the table below and trigger to create. Take Single-point information as an example: IOA100 corresponds to M100, IOA101 and M101 and so on. The same rule applies to 2 nd ~ 16 th remote devices. Refer to section 9.3.5 for details on type id parameters and codes.
9-14 position of D device #682 Packed output circuit information of protection equipment corresponds to the starting position of D device #683 Packed single-point information with status change detection corresponds to the starting position of D device #684 Measured value, normalized value without quality descriptor corresponds to the starting position of D device CR Number Value in the control register Description #672 100 Single-point information corresponds to the starting position from M100 #673 200 Double-point information corresponds to the starting position from M200 #674 300 Step position information corresponds to the starting position from D300 #675 400 Bitstring of 32 bit corresponds to the starting position from D400 #676 500 Measured value, normalized value corresponds to the starting position from D500 #677 600 Measured value, scaled value corresponds to the starting position from D600 #678 700 Measured value, short floating point value corresponds to the starting position from D700 #679 800 Integrated totals corresponds to the starting position from D800 #680 900 Event of protection equipment corresponds to the starting position from D900 #681 1000 Packed start events of protection equipment corresponds to the starting position from D1000 #682 1100 Packed output circuit information of protection equipment corresponds to the starting position from D1100 #683 1200 Packed single-point information with status change detection corresponds to the starting position from D1200 #684 1300 Measured value, normalized value without quality descriptor corresponds to the starting position from D1300