Chapter 10 DeviceNet Communication Module AH10DNET 10.8 Special Operation in Slave Mode 10.8.1 Slave Mode and Mapping Areas Setting AH10DNET-5A can be set to the DeviceNet slave through the software. When AH10DNET-5A works as a slave, the default input/ output length is 8 bytes and maximum input/output data length is 1000 bytes. There are two methods of setting AH10DNET-5A to the slave. While the slave mode is being set, the starting addresses of the mapping areas of AH10DNET-5A can be set simultaneously. Method 1: Setting slave mode and the starting addresses of the mapping areas through ISPSoft and DeviceNet Builder 1.
PC accesses an AH500 series CPU module via USB after connecting the device according to the following figure. 10-31 PS05 viceNet Builder CPU530-EN AH10DNET-5A P S05 C PU530-EN 10DNET RS232 The introduction in this section is made in the USB communication method. ISPSoft, select “File” >> “New” >> “New” and then the following dialog box appea the corresponding PLC. The PLC used in this section is AHCPU530-EN. PS05 CPU530-EN AH10DNET-5A P S05 C PU530 -EN 10DNET made in “New” HCPU5 the and t 30-E USB comm hen the fol N. unication method. lowing dialog box appea