Chapter 11 DeviceNet Remote I/O Module AHRTU-DNET 4. “10DNET” on the above window is the abbreviation of AH10DNET-5A. Double click the AH10DNET-5A icon and then the parameter configuration dialog box of AH10DNET-5A will pop up. Set Start D device address mapped by INPUT area (input mapping starting address) and Start D device address mapped by OUTPUT area (output mapping starting address) on the Parameters of I/O Mapping interface as follows. The two addresses are set to D500 and D1000 respectively in the example. Click “OK” after the setting is completed. 11-63