AH500 Operation Manual 9. Increasing the efficiency of configuring the hardware through an USB cable and ISPSoft The AH500 series CPU module provides a standard USB 2.0 interface. USB 2.0 increases the data transfer rate, and decreases the time it takes to download the program, monitor the program and configure the hardware. Besides, users do not need to buy a communication cable for the CPU module. They can use a general USB cable to connect to the AH500 series CPU module. 10.
Serial control interface with multiple functions CPU530-RS2 CPU530-EN RUN BUS FAULT ERROR RUN ERROR BUS FAULT COM1 COM2 SYSTEM COM SYSTEM Ethernet C O M 2 USB COM USB C O M 1 AHCPU500/510/511/520/530-RS2 provides two DB9 serial control interfaces, i.e. COM1 and COM2. AHCPU500/510/511/520/521/530/531-EN provides one DB9 serial control interface, i.e. COM. Users can set the DB9 serial control interface to RS-232, RS-485, or RS-422 according to the application environment. The data transfer rate can be increased from 9600 bps to 1 Mbps. AH500 basic series CPU module (AHCPU500/510/520/530):
After users set the PLC Link in NWCONIFG in ISPSoft, they can exchange the data with a device through the RS-485 serial control interface, and do not need to write any program. AH500 advanced series CPU module (AHCPU511/521/531): After users set the PLC Link in HWCONIFG in ISPSoft, they can exchange the data with a device through the RS-485 serial control interface, and do not need to write any program. 11. High-speed Ethernet communication interface AHCPU500/510/511/520/521/530/531-EN is equipped with a 10/100 M Ethernet communication interface, and supports emails, webs, and socket services. AH500 basic series CPU module (AHCPU500/510/520/530):
After users set the PLC Link in NWCONIFG in ISPSoft, they can exchange the data with a device network through the Ethernet communication interface, and do not need to write any program. AH500 advanced series CPU module (AHCPU511/521/531): After users set the PLC Link in HWCONIFG in ISPSoft, they can exchange the data with a device through the Ethernet communication interface, and do not need to write any program. The status or the error message related to the system is sent to users’ email boxes immediately. Users do not need to be on the spot to understand the problem. 12. Memory card The memory card has the following functions. System backup:
The user program, the CPU parameters, the module table, the setting value in the device System recovery: The user program, the CPU parameters, the module table, and the setting value in the device Parameter storage: The value in the device Log storage: The system error log and the system status log 1-14