AL-MX300 Series User's Guide ❏ Be careful not to touch the fuser, which is marked with a caution label, or the surrounding areas. If the printer has been in use, the fuser and the surrounding areas may be very hot. If you must touch one of these areas, wait 40 minutes to allow the heat to subside before doing so. * caution label ❏ Do not insert your hand deep into the fuser unit as some components are sharp and may cause injury. ❏ Never push objects of any kind through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. ❏ Do not sit or lean on the printer. Do not put heavy objects on the printer.
❏ Do not use any kind of combustible gases in or around the printer. ❏ Never force the printer’s components into place. Although the printer is designed to be sturdy, rough handling can damage it. ❏ Do not leave jammed paper inside the printer. This can cause the printer to overheat. ❏ Never spill liquid of any kind on the printer. ❏ Adjust only those controls that are covered by the operating instructions. Improper adjustment of other controls may result in damage and may require repair by a qualified service representative. ❏ Do not turn off the printer: -After turning on the printer, wait until the following screen appears on the LCD panel.
The screen varies depending on which mode is selected for Default Mode in the Admin Settings menu. Safety Instructions 19