Setting Up the Amiga 2000 2-5 uncover the mouse ball.) ' out, see the "Cleaning the Mouse" section in Chapter 9 to find out how to piece of foam that holds the mouse ball in place. (If you don't get all the foam Before attaching a new mouse, turn the mouse upside down and pull out the Attaching the Mouse H Also, when connecting cables to the Amiga, make sure you're plugging the I) correct cable into the proper connector. Remember, don't try to force a cable into a connector; double-check to make sure the cable matches that connector. i | on/off switch. ^_^ your Amiga system components, and power them all on or off with a single hardware store.
This would allow you to connect all the electrical plugs from f j Additionally, we suggest getting a multi-outlet electrical power strip from a right side. I \ Note where the on/off switch is located: it's on the back of the main unit, on the Turn the computer off before inserting or removing any connectors. i i r tation. save the piece to replace in the drive unit opening for protection during transpor- f | the cardboard piece; this releases the cardboard piece so it slides out easily. Also, t drive during shipping. Make sure you press the drive button before you remove r i because care was not taken in removing the cardboard piece protecting the disk drive.
This sleeve sits inside the disk drive opening and is designed to protect the __ Note the cardboard sleeve in the disk drive. Many Amiga returns occur simply r_f While it's not difficult to assemble the Amiga, it is possible to damage it if you I | don't follow the instructions. Before setting up your Amiga, be sure to read each instruction carefully. Before You Start n