Chapter 3: RAID Confi guration To Test the LED Indicators for an Enclosure 10. You can also test the LED indicators for the enclosure by right-clicking on Blink Enclosure on the screen as shown in the fi rst graphic on the previous page. 11. To stop the LED blinking test, simply click OK when prompted to do so as shown below. To Display the Property for an Enclosure 12. You can also display the property for the enclosure by right-clicking on "Property" on the screen as shown in the fi rst graphic on Page 3-34. 13. Double-click on "Property" to display the property of the selected device. The following screen appears. Click X at the upright corner to close this window. 3-35