Starting an Application in Configuration Mode The start command in application-hosting configuration mode is equivalent to the app-hosting activate appid and app-hosting start appid commands. The no start command in application-hosting configuration mode is equivalent to the app-hosting stop appid and app-hosting deactivate appid commands. Note If the start command is configured before an application is installed, and then the install command is configured, Cisco IOx automatically performs internal activate and start actions. This allows the application to be automatically started by configuring the install command. SUMMARY STEPS 1. enable 2. configure terminal 3.
app-hosting appid application-name 4. start Application Hosting Starting an Application in Configuration Mode Command or Action Purpose Step 5 switchport mode trunk Example: Device(config-if)# switchport mode trunk Sets the interface into permanent trunking mode and negotiates to convert the neighboring link into a trunk link. Step 6 exit Example: Device(config-if)# exit Exits interface configuration mode and returns to global configuration mode. Step 7 app-hosting appid name Example: Device(config)# app-hosting appid iox app _ Configures an application and enters application-hosting configuration mode. Step 8 app-vnic AppGigabitEthernet trunk Example:
Device(config-app-hosting)# app-vnic AppGigabitEthernet trunk Configures a trunk port as the front-panel port for an application, and enters application-hosting trunk-configuration mode. Step 9 guest-interface guest-interface-number Example: Device(config-config-app-hosting-trunk)# guest-interface 2 Configures an application’s interface that is connected to the AppGigabitEthernet interface trunk. Step 10 end Example: Deviceconfig-config-app-hosting-trunk)# end Exits application-hosting trunk-configuration mode and returns to privileged EXEC mode. Application Hosting 18