AS Series Module Manual 1.3 Installation _1 1.3.1 Installing a Module 1. Press the clip rings if they are out as the image 1 shown. Push the module to the desire position until you hear a click to finish installation. 2. Link the I/O modules on the right side of the PLC and make sure they are hooked together. Push the 3. After you installed the module, fasten the screws on the modules to secure the module on the DIN rail. modules into the DIN rail until you hear a click. 1 2 1 If there is a vibration source near the installation site, install anti-vibration baffles on the sides of the AS Series modules for better stabilization, such as the gray baffles show below. 1-8