3. HARDWARE SETUP 3.5.1 Installing Memory Using RIMM/C-RIMM The memory module (RIMM/C-RIMM) will fit in only one orientation. IMPORTANT: Do not touch the memory module’s connectors. Handle the mod- ule only by the edges. RIMM0 RIMM1 RIMM Sockets PARALLEL PORT OPTIONAL 2 1 4 3 P3C-LS / L / S RIMM with Heat Spreader System Memory 3. H/W SETUP C-RIMM P3C-LS/L/S 184-Pin RIMM Sockets 1. Make sure that the notch keys in the module are aligned with the small ribs inside the RIMM sockets. RDRAM (with heat spreader) MOUNTING NOTCH NOTCH KEYS CONNECTORS RIBS (inside socket) EJECTOR (TOP VIEW) 2.
With the ejectors in the open position (as shown), push down gently but firmly on the memory module until it snaps into place. The guides on the socket’s ejectors should go through the two mounting notches on the module and the ejectors should close. If necessary, push the ejectors inward to secure the mod- ule in place. Removing Memory 1. To release a memory module, push both ejectors outward and pull the module straight up and out of the RIMM sockets. 26 ASUS P3C-L / P3C-S / P3C-LS User’s Manual