Controller Editor Object Menu Pending Errors Displays any errors that have occurred since the last ENABLE POWER command. For details, see the topic Pending Errors Log on page 1112. Message History Displays the Message History window, which is used to view the system message log. Controller Digital I/O Displays the controller digital I/O window. For details, see the topic Digital I/O Window on page 166. Help Displays the online help for the Controller Editor. Refresh Editor Refreshes the contents of the Controller Editor window. Close Closes the Controller Editor. Set Time Displays a prompt to verify that you want to set the controller time to match the time detected on the connected PC.
Click OK to proceed; click Cancel to quit. Reboot V+ Displays a prompt to verify that you want to save the system specifications to the boot disk before initiating a reboot of the controller. Click Yes to save the specifications and proceed; click No to proceed without saving the specifications; click Cancel to quit. Servo Reset Resets the servos. A "Working...." message and progress bar is displayed while the command is processed. Save All Robot Specs Saves all robot and motor specifications to the V+ boot disk. A "Working...." message and progress bar is displayed while the command is processed.
Save Memory to File Saves all V+ files, program files, and/or variable files to a spe- cified location on the PC. View eV+ Log Views the eV+ event log. This is only displayed if the controller ACE User's Guide, 3.6.x 18316-000 Rev A Page 100