omron — Quattro Robot Platform

Quattro Robot Platform Belt Control Group (from the Belt Object Editor) The emulation speed controls are available only when emulation mode is enabled. For more details on the Encoder diagnostics editor, see External Encoder Diagnostics on page 1115. For more details on the Belt object editor, see Belt on page 809. Belt and Sensor Calibrations In emulation mode, the Belt and Sensor calibration wizards are different - they use 3D visualization win- dows, which allow you to drag the calibration objects to the desired positions. For more details, see Emu- lation Mode Wizards on page 185. Quattro Robot Platform When the Quattro robot is used, the correct platform must be set in V+.

The platform information can be displayed by typing the ID command in the V+ Monitor window, as shown in the following figure. Output of ID Command Showing the Quattro Platform Configuration If you need to change the loaded platform, open the Controller editor and click Configure > Configure Robots . You will perform the robot-selection and platform-selection steps described in the section Enabling Emulation Mode on page 1093. For more details on using the V+ Monitor window, see Monitor Window on page 777. For more details on the Controller editor, see Controller Editor on page 97. ACE User's Guide, 3.6.x, 18316-000 Rev A Page 1101