Adept AnyFeeder Object Adept AnyFeeder Object The ACE software contains a control panel for the AnyFeeder object, which allows you to set and test vari- ous Adept AnyFeeder parameters. For Adept AnyFeeder hardware installation details, see the Adept AnyFeeder User's Guide . NOTE: When emulation mode is enabled, all feed-operation durations are now emulated. However, this does not apply to: error reset, initialization, operation abort, or Firmware restart, as these operations are not supposed to be called during the feed cycle. For more details on emulation mode, see Emulation Mode on page 1089.
Creating an AnyFeeder Object To create a new AnyFeeder object, right-click in the folder area of the Workspace Explorer, and select: New > Device > Feeders > AnyFeeder The Create New AnyFeeder interview wizard opens, which is used to create and position the AnyFeeder object in the workcell. Simply follow the interview wizard screens to complete the operation. NOTE: This feature operates differently in emulation mode. For details on emulation mode wizards, see Emulation Mode Wizards on page 185. Once the AnyFeeder object is created, use the AnyFeeder object editor to set the operating parameters for the AnyFeeder.
To open the AnyFeeder object editor, double-click the AnyFeeder object in the folder area of the Workspace Explorer. ACE User's Guide, 3.6.x 18316-000 Rev A Page 138