Using the V+ System Configuration Dialog 2. Right-click on any digital input or output node. Choose the output block or input block numbers. Ensure that only one instance of each output and input block numbers exists on the network. After completing the above steps, you must map the output and input blocks to I/O numbers, as described in the next section. 3. Click Save to write changes to the FireWire nodes. Using the V+ System Configuration Dialog The V+ System Configuration Dialog is used to map the output and input blocks to I/O numbers, as described in the following steps: 1. From the Controller Editor , click Configure V+ . The V+ System Configuration dialog box opens.
V+ System Configuration Dialog ACE User's Guide, 3.6.x 18316-000 Rev A Page 196