Adding, Editing, or Removing a Statement Adding, Editing, or Removing a Statement NOTE: After any changes are made (add, edit, or delete statements) to the configuration file, it must be saved. For details, see the section Saving the Configuration File on page 226. To add a statement: 1. Select an item in the Section group and then click Add . The Add Statement dialog opens, as shown in the following figure. 2. Select the Statement Type 3. Set the item values. As the item values are changed, the complete statement is shown in the Com- posed Statement area. If an invalid value is entered, an error message will be displayed when Accept is clicked. 4.
Click Accept to save the new statement; or, click Cancel to close the editor without saving. To edit a statement: 1. Select an item in the Section group, select an item in the Statements group, and then click Edit . The Edit Statement dialog opens (it is similar to the dialog shown in the following figure; however, the Statement Type selector will be dimmed). 2. Edit the item values. As the item values are changed, the complete statement is shown in the Com- posed Statement area. If an invalid value is entered, an error message will be displayed when Accept is clicked. 3. Click Accept to save the new statement; or, click Cancel to close the editor without saving.
To remove (delete) a statement: ACE User's Guide, 3.6.x 18316-000 Rev A Page 222 Item Description Add Opens a dialog for adding a new statement to the selected section. For details, see the section Adding, Editing, or Removing a Statement on page 222. Edit Opens a dialog for editing the selected statement. For details, see the sec- tion Adding, Editing, or Removing a Statement on page 222. Remove Opens a dialog for deleting the selected statement. For details, see the sec- tion Adding, Editing, or Removing a Statement on page 222. Save Saves the current changes. At least one item must be changed to activate the Save button.
For details, see the section Saving the Configuration File on page 226. Done Closes the V+ System Configuration window.