Camera Properties l Controller Specify the controller attached to the conveyor belt. l In the following three fields, a green square to the right of the field indicates that the signal is On, a black square indicates that the signal is Off, and a grey square indicates that the signal has not been set (=0). l On/Off Specify the signal used to turn the conveyor belt on and off. l Fast/Slow Specify the signal used to switch the conveyor belt between fast and slow speeds. l Reverse/Forward Specify the signal used to switch the conveyor belt between reverse and forward directions.
l Synchronize belt with grab If checked, the belt is started when an image acquisition is requested, and stopped after the image has been acquired. Delay before grab sets the milliseconds, before the scan starts, to start the conveyor belt move- ment. ACEUser's Guide, 3.6.x, 18316-000 Rev A Page 344