Gripper Clearance Tool Three Histograms Around a Part Related Topics See "Configuring Gripper Clearance Properties" See "Gripper Clearance Results" Image Histogram Tool Configuring Gripper Clearance Properties The tab of the selected histogram is highlighted. Clicking on the origin or outline of a his- togram with the mouse will select it, highlighting the tab for that histogram. (The cursor will change to either a two- or four-headed arrow near the outline, or a small cross without arrows near the origin.) You can also select a histogram by clicking on its tab.
Gripper Clearance Tabs with Histogram 2 Selected When Adding a new histogram, the tool copies the last (highest numbered) histogram. The height and width are rounded to even numbers, the rotation will be zero, and the offset from the copied histogram will be +20 in both X and Y. ACEUser's Guide, 3.6.x, 18316-000 Rev A Page 482