ACE Sight Belt Calibration At the bottom of the Wizard screens you will usually find I/O , Power , Previous , Next , Cancel , and Help buttons. Some of these, particularly Previous , may be greyed-out when that action is not appro- priate.
(Many procedures require that you click Cancel and start over, rather than backing up with Previous .) Related Topics Standalone Camera Calibration ACE Sight Belt Calibration Interview Wizard ACE Sight Belt Calibration Wizard ACE Sight Camera Calibration Interview Wizard ACE Sight Camera Calibration Wizard - Automated, no Belt ACE Sight Camera Calibration Wizard - Automated, w/ Belt ACE Sight Camera Calibration Wizard - Automated Upward-Looking ACE Sight Camera Calibration Wizard - Automated, Arm-mounted ACE Sight Camera Calibration Wizard - Manual, no Belt ACE Sight Camera Calibration Wizard - Manual w/Belt ACE Sight Camera Calibration Wizard - Manual, Upward-looking ACE Sight Camera Calibration Wizard - Manual, Arm-mounted ACE Sight Belt Calibration ACE Sight Belt Calibration calibrates a robot to a conveyor belt.
This calibration is necessary when the robot will handle parts that are moving on a conveyor belt. This calibration is available in Emulation Mode. Requirements l The robot, controller, and belt must be correctly connected and functioning. l The PC running the ACE Sight software must be connected to the controller for the robot and belt. l The belt, as well as the robot and gripper, must be defined in the ACE Sightsoftware. To add a belt to the Workspace, right-click in the Tree structure of the Workspace Explorer and select: ACEUser's Guide, 3.6.x, 18316-000 Rev A Page 627