ACE Sight Camera Calibration 1. Align the robot with the target. 2. Click Here. The following steps are repeated for n = 2 through 4. A magenta circle will remain for each target instance that was found, so, at the end, you will see four circles. Example Magenta Circle l Take a Picture of the Calibration Target 1. Move the robot to the location where the picture is taken. 2. Click Run. The located target should be identified with a magenta origin marker. If this isn't displayed after clicking Run, this calibration will fail. This will occur if the belt advances the target past the downstream limit. l Advance the Belt Do not touch the target.
l Teach the Robot Position at Object n ACEUser's Guide, 3.6.x, 18316-000 Rev A Page 712